Done and done!

Sam Mechatronics 2 Comments

Finally finished the nut sorter, demo and report! Final report started at 2pm yesterday and had to rush around to get it printed by 5pm. I think we pulled it a little too close this time…
This is our final design. For the demo we sorted all the nuts correctly but the toonie slipped through and fell into a cup. Our total sorting time was 39 seconds.

Other shots from the day of the demo. The fastest sorting time was just under 8 sec, impressive!

Alright, time to get some sleep.

SamDone and done!

Comments 2

  1. Horace

    All those Buskro experience is paying off I see.

    Haha, need some more detail to figure out what that big box up at the top does. My guess is that all the sensors are fitted in there?

Leave a Reply

Your email address will not be published. Required fields are marked *